ZENN
iO
AVANCE
Y
TECNOLOGÍA
www.zennio.com
40
¾
When receiving a “0” through this object, the input turns into
the “enabled” state again (without taking into consideration the
actions carried out while being disabled)
2.3.2.
SENSOR
A Switch/Sensor connected to an input, consists of an electrical mechanism which may
have its contacts open or closed under normal conditions. These mechanisms don’t
recover their normal position automatically as with the push button.
A transition of a digital signal from low/high/low is called "Edge":
¾
Falling Edge:
Closed contact to Open Contact.
¾
Rising Edge:
Open contact to Closed Contact.
By selecting a Switch/Sensor input, “[Switch/Sensor] Edge” Communication object will
be sent to the BUS every time a rising/falling Edge is detected
2.3.2.1.
FALLING EDGE :
Set the value to be sent to the BUS in the transition of the digital signal from high
to low:
¾
0
¾
1
¾
Switching 0/1
2.3.2.2.
RISING EDGE :
Set the value to be sent to the BUS in the transition of the digital signal from low
to high:
¾
0
¾
1
¾
Switching 0/1
2.3.2.3.
SENDING OF "0" DELAY
Time to wait before sending value “0” through the “[Switch/Sensor] Edge”
communication object when this value has been detected on an incoming edge.
2.3.2.4.
SENDING OF "1" DELAY
Time to wait before sending value “1” through the “[Switch/Sensor] Edge”
communication object when this value has been detected on an incoming edge.
