GetFace
IP
Surface
installation
‐
Frame
‐
1
module
ZVP
‐
CB1M
Assembly
instructions
©
Zennio
Avance
y
Tecnología
S.L.
Ed.
2
For
more
info
www.zennio.com
Page
1
/
1
ASSEMBLY OF THE FRAME
1
Please remove the additional module from the enclosure
and place the metallic auxiliary parts supplied with the frame.
2
Place the additional module enclosure correctly levelled on
the wall and drill two holes for the expanding plugs. Recover the
cables and fix the enclosure with the screws (included).
3
Connect the bus to the additional module.
4
Fix the additional module with the supplied screws.
5
Place the frame.
6
Fix the frame by using the supplied Allen key.
Note:
It is recommended to install the backplate (ZVP-BPLA1) if the wall surface irregularity is greater than 0.5mm.
Dimensions: 128 x 106.5 x 27.5 mm