Zenith D52WLCD Series, Installation And Operating Manual, Warranty, Page: 26 / 60

P A G E 2 6
206-03816
EZ Scan
Use pages 9-14 to connect external
equipment to your TV. If you have not
done so, plug in your TV to a standard
120V 60Hz power outlet.
If you have not done so, remove the
back of the remote and put in two AA
batteries. Make sure batteries are prop-
erly installed (check the +/– symbols).
With the remote control in hand, press
the POWER button to turn on your TV.
Press the MENU button on the remote
control, then use the UP/DOWN arrow
button to select the Setup menu.
Press ENTER or the RIGHT arrow button
to access the Setup menu.
Use the UP/DOWN arrows to select EZ
Scan.
Press ENTER or the RIGHT arrow to
access the EZ Scan menu, then use the
UP/DOWN arrows to select: ANT1 Air,
ANT1 Cable, ANT2 Air, ANT2 Cable
Press ENTER or the Right arrow button
to start the EZ Scan channel search.
1
2
3
4
5
Automatically finds analog channels available through
antenna or cable inputs, and stores all active channels in
memory on the channel list.
1 2 3
4 5 6
7 8 9
0
tv
mode light power
antenna
video front
comp1 rgb
vcr cable dvd sat
mute
swap pipch- pipch+ pip
menu
record stop
pause rew
play ff
exit
flashbk surf
freeze
vol ch
ratio
comp2
skip
source
enter
4/6
4
5/7/8
5/7/8
back of
remote
3
6
7
8
Main Source
PIP Source
EZ Scan
G
CH. Add/Del/Surf
CH. Label
F
Prev.
Ant 1 Air
Ant 1 Cable
Ant 2 Air
Ant 2 Cable
SETUP
SETUP
VIDEO
VIDEO
AUDIO
AUDIO
TIME
TIME
LOCK
LOCK
SPECIAL
SPECIAL
4/6