Zenith D52WLCD Series, Installation And Operating Manual, Warranty, Page: 10 / 60

P A G E 1 0
206-03816
Cable Box Connections
Locate the Antenna/Cable 2 jack on the
back of your TV. Connect the cable that
runs from the wall directly to the jack.
Now find the Loop Out jack.
Connect the cable from this jack to the
Input jack on the back of your cable box.
Locate the Output jack on the back of
your cable box. Connect this to the
Antenna/Cable 1 jack on the back of your
TV.
To view the premium stations, press the
TV button on your remote and select the
other Cable source (Ant/Cable 1). Then
tune the channel number on your cable
box for HBO, CINEMAX, SHOWTIME, etc.
To view non-premium channels press the TV
button and select Ant/Cable 2. Then run EZ
Scan to find all available channels and
store them in memory.
This can be combined with any other
equipment you may want to hook up, see
following pages. Connect cable service
wire directly to the TV, loop out from the
TV, then to the cable box. From there, the
cable box output connects to the next
device in the connection series, until the
last device, which connects back to the
Antenna/Cable 1 jack on the TV.
1
2
3
4
Some cable services require the use of a cable box to decode pre-
mium channels and pay-per-view. Using the Loop Out to Decoder
connection option, and programming your remote, you can con-
nect your cable box so that you only need your MBR remote to
tune to premium and non-premium channels. By connecting a
cable box directly to your TV, as shown to the LOOP OUT, you
make the cable box another available channel tuning source using
your remote.
RGB
(XGA)
PC/DTV INPUT
ANT/
CABLE2
INPUT
ANT/
CABLE1
INPUT
LOOP
OUT
COMPONENT
INPUT 1
480i
/
480p
/
720p
/
1080i
COMPONENT
INPUT 2
480i
/
480p
/
720p
/
1080i
In Out
Antenna
Cable TV
Wall jack
RF coaxial wire
(75 ohm)
Cable box