2 Safety | 2.5 Safety Devices and Interlocks
ZEISS
Position and Figure of the Safety La-
bel
Description
14
At the CEE connector
Risk of electrical shock
Residual voltage at the mains plug after unplug-
ging.
Wait at least 5 s after unplugging the mains plug
before touching the pins of the mains plug.
354700-7113-000
The microscope should be
approved by the
national regulations.
Do not remove any parts.
X-Rays produced
when energized
CAUTION
X-Rays produced when energized
The microscope should be approved by the na-
tional regulations.
Do not remove any parts.
Reorder no. 354700-7113-000
347800-0003-000
Skin burns under contact
Do not touch
This area may get hot
Hot Surface
CAUTION
Hot Surface
Skin burns under contact
Do not touch
This area may get hot
Reorder no. 347800-0003-000
347800-003-200
CAUTION
Hot surfaces inside during bakeout
procedure.
Do not place any combustible objects on
the grids of the electron optical column.
Only authorized service staff are allowed
to service the equipment.
Disconnect power and let surfaces cool
before opening.
Burn hazard
Burn hazard
Hot surfaces inside during bakeout procedure.
Do not place any combustible objects on the
grids of the electron optical column.
Only authorized service staff are allowed to ser-
vice the equipment.
Disconnect power and let surfaces cool before
opening.
Reorder no. 347800-003-200
Position and Figure of the Type Plate
Description
11
At the rear of the microscope
16 A / SCCR 3.5 kA
Manufactured in year 2020
230 VAC ± 10%
208 VAC ± 10%
50 - 60 Hz
Made in Germany
356100-9057-100
Serial number
Carl Zeiss Microscopy GmbH
Carl-Zeiss-Straße 22
73447 Oberkochen, Germany
Sigma 300
1/N/PE
2/PE
The
Type plate
contains a unique serial number,
the Sigma model designation with the according
part number, the manufacturing year, and the
mains voltage for which the Sigma is configured.
Order no. 356100-9057-000 (Sigma 300)
Order no. 352100-9903-000 (Sigma 500)
2.5 Safety Devices and Interlocks
In order to prevent injuries and/or property damage, the Microscope System is equipped with sev-
eral safety devices and interlocks. Defects and other damaged safety devices may cause injuries
and property damage. In case of damage or defect, the affected parts of the Microscope System
must be taken out of operation immediately and be secured against unintentional use.
For verifying the safety of the Microscope System, please contact your ZEISS service representa-
tive. Please keep the service logs and logbooks.
22
Instruction Manual ZEISS SIGMA series | en-US | Rev. 7 | 352102-9344-006
