Zeiss S88, Instructions For Use Manual

Page: 40 / 182

40
Description
G-30-1426-en S88 Floor Stand with Lifting Column Issue 9.0
Printed on 28. 01. 2009
Stand base with lifting column
1 Lifting column
2 Handle
for moving the stand.
3 Support
for hanging up the foot control panel during transport.
4 Up/down switch
for setting the optimum viewing height of the surgical microscope, for
moving the system up into the standby position or down into the trans-
port position.
As long as you keep switch (4) pressed, lifting column (1) in the stand
base moves upward or downward, depending on the switch position.
When you release the up/down switch, the lifting column stops imme-
diately.
The switching technology causes a dead time of approx. 2 seconds at
the upper and lower end positions of the lifting column. After this time,
you can move in the opposite direction again by activating switch (2).
5 Cable deflectors
are provided to prevent cables on the floor from being run over and
damaged.
6 Locking pedal
Press once to lock the stand in position.
Press a second time to release the locking pedal.
7 Steerable casters
The four steerable casters on the stand base permit easy positioning
in the OR.
8 Cable support (2x)
for winding up the power cord and the cable of the foot control panel.