Zeiss S8, Instructions For Use Manual

Page: 130 / 148

130
Maintenance / Further information
G-30-1346-en S8 Floor Stand Issue 4.0
Printed on 05. 06. 2001
Changing the xenon lamp module
Warning!
The lamp module must only be changed by appropriately trained per-
sonnel.
Improper handling of the xenon lamp may lead to damage or injury.
Please note the following points:
• First switch off the ceiling mount (floor stand) at the power switch.
• Only change the lamp module after it has cooled down completely!
Due to the high pressure inside the hot lamp, there is the risk of explo-
sion in case of an error. The hot surface of the xenon lamp may also
cause burns.
• Only change the lamp module after switching off the instrument. The
igniter produces high voltage when switched on.
• Press button (1), the lamp module is slightly ejected.
• Pull out the lamp module to the stop.
• Slide the original transport case (2) over the lamp module, making
sure that the bolt (3) engages in the bore (4). This unlocks the stop.
• Remove the old lamp module and install the new lamp module by pro-
ceeding in the reverse order.
Pack the old lamp module (5) in the transport package of the new lamp
module. Fill in the enclosed return card and send the old lamp module to
the nearest Zeiss service agency.
Note:
•
Only use the original transport case (2), as it also provides explosion
protection, should xenon lamps be defective.