Zeiss S100/OPMI pico, Instructions For Use Manual

Page: 75 / 278

Version 7.0
G-30-1781-en
Page 75
S100 / OPMI pico System Overview
LED light source
Connector panel for the LED light source
1 Light guide socket
The light guide socket is used to direct the light from the light source to
the surgical microscope.
2 Strain relief device
The strain relief device prevents inadvertent unplugging of the power
cable.
3 Power switch
When the device is switched on, the green indicator light in the power
switch is lit.
4 Power supply socket
The power cord connects the device to the power socket. Only connect
the system to a wall outlet which is properly grounded.
5 Potential equalization
This connector can be used for placing other active devices at the same
ground potential or for redundant grounding to protective earth.
Fig. 39: Connector panel for
the LED light source
3
4
1
2
5