Zeiss S100/OPMI pico, Instructions For Use Manual

Page: 160 / 278

Operation S100 / OPMI pico
Version 7.0
Page 160 G-30-1781-en
SDTV FORMAT submenu
If a conventional display device (monitor, projector, etc.) with 4:3 format is
connected, the "SDTV FORMAT" submenu allows you to choose between
"LETTERBOX" and "SIDE-CUT" visualization.
LETTERBOX
Use this setting for display devices that are not compatible with the 16:9 wide
screen format. A black bar will appear at the top and bottom of the screen
and the image will be displayed in the 16:9 format.
SIDE-CUT In this mode, the sides of the image will be "cut", leaving the center of the
image to be displayed with a 4:3 aspect ratio.
Proceed as follows to select a format and to load the respective configuration:
• Press the "config" key for approx. 5 seconds to access the installation
menu.
• Select menu item "SDTV FORMAT MODE" in the installation menu using
the control keys and press the "enter" key.
 The following menu appears:
• Use the control keys to select the required mode.
 The selection is displayed with an arrow.
 The properties of each format are explained at the bottom of the
screen.
• Press the "enter" key to save the changes.
 The selection is saved. The camera restarts after you have confirmed
that the setting is to be applied.
• If you do not want to save any changes, select menu item "CANCEL" to
return to the installation menu. As a result, the image display on the
screen will be reset to the setting present when the submenu was opened.
SDTV FORMAT
 LETTERBOX
SIDE-CUT
CANCEL
DISPLAY VIDEO PICTURE WITH BLACK STRIPES AT TOP AND BOTTOM