Zeiss S100/OPMI pico, Instructions For Use Manual

Page: 159 / 278

Version 7.0
G-30-1781-en
Page 159
S100 / OPMI pico Operation
DVI/HDMI OUT submenu
The "DVI/HDMI OUTPUT" allows switching between video formats "PC
MODE" and "VIDEO MODE" when a high-resolution display device (monitor,
projector, etc.) is connected. To do this, proceed as follows:
• Press the "config" key for approx. 5 seconds to access the installation
menu.
• Select menu item "DVI/HDMI OUT" in the installation menu using the
control keys and press the "enter" key.
 The following menu appears
• Use the control keys to select the required mode.
 The selection is displayed with an arrow.
 The properties of each format are explained at the bottom of the
screen.
• Press the "enter" key to save the changes.
 The selection is saved and you return to the installation menu.
• If you do not want to save any changes, select menu item "CANCEL" to
return to the installation menu. The video format is set as it was when the
submenu was accessed.
You can find the correct setting for your connected monitor or TV in the user
manual pertaining to the device.
If you cannot find any information on the right setting, we recommend the PC
MODE (default) setting for display devices with DVI port. We recommend the
VIDEO MODE setting for display devices with HDMI port.
DVI/HDMI OUTPUT RANGE
 PC MODE (255 DEFAULT)
VIDEO MODE (235)
CANCEL
ADJUST DVI/HDMI OUTPUT FOR SPECIAL HDMI MONITOR SIGNAL