Zeiss S100/OPMI pico, Instructions For Use Manual

Page: 13 / 278

Version 7.0
G-30-1781-en
Page 13
S100 / OPMI pico Safety Measures
Requirements for operation
Prior to the very first use
A ZEISS Service representative or an expert authorized by ZEISS will install the
system. Please make sure that the following requirements continue to be met
for further operation:
 If you determine that one of the symbols or the lettering (effective
Page 22) is missing or illegible on your device, please contact ZEISS Service
or the ZEISS authorized partner.
 The connecting components have been properly connected. The screw
connections have been firmly tightened.
 All cables and plugs are in perfect condition.
 Determine the supply voltage at the place of installation and set the volt-
age of the device accordingly.
 Check whether the device fuse used is the correct one as specified on the
fuse label.
More specific information about the floor stand:
 The main plug must only be connected to a socket with
a faultless protective ground conductor.
 The device is connected with the power cord supplied.
Additional information about wall and ceiling mount:
 The device may only be connected to a power supply network which has
a faultless protective ground conductor.
WARNING The device must not be modified without any approval!
This device must not be modified without the manufacturer's approval.
If the device is modified, appropriate examinations and tests must be per-
formed to guarantee the further secure use of the device.
The manufacturer is not liable for damages caused by an unauthorized use
of the device. Furthermore, this will invalidate any rights to make a claim
under the warranty.