Zeiss S100/OPMI pico, Instructions For Use Manual, Page: 118 / 278

Preparations for use S100 / OPMI pico
Version 7.0
Page 118 G-30-1781-en
Mounting the flat screen monitor on the carrier arm flat screen monitor
Mounting the flat screen
Before mounting a flat screen on the carrier arm flat screen monitor, make
sure it meets the following specifications:
– Compliance with VESA standard (Video Electronics Standards Associa-
tion):
– 75 mm x 75 mm hole spacing or
– 100 mm x 100 mm hole spacing
– Maximum total weight of the flat screen: 9 kg
• Press flat screen (3) against the carrier arm so that the holes in the carrier
arm (2) coincide with those provided in the flat screen.
• Firmly tighten screws (1).
Cable routing in the carrier arm flat screen monitor
• Remove the clamping plate (5) from the cover plate (6) on the underside
of the carrier arm flat screen monitor.
• Place all connecting cables required for the monitor in the cable guide (4).
Leave sufficient cable loops in order to freely position the monitor without
damaging cables or plugs.
• Attach the clamping plate (5) to the cover plate (6) again.
NOTE Overload of the carrier arm flat screen monitor!
When overloaded, the carrier arm flat screen monitor may break off or bend
or the suspension system may topple over.
• The monitor bracket may be loaded with the maximum weight of 9 kg.