Zeiss S100/OPMI pico, Instructions For Use Manual

Page: 116 / 278

Preparations for use S100 / OPMI pico
Version 7.0
Page 116 G-30-1781-en
Attachment of instrument tray and carrier arm flat screen
monitor to the S100 floor stand
Ergonomic positioning the carrier arm flat screen monitor and instrument tray
In order to ergonomically position carrier arm flat screen monitor (2) and in-
strument tray (3), loosen the adapter (1), adjust side and height and screw it
tight again:
Instrument tray
• Hold the instrument tray with one hand and unscrew the four locking
screws at the adapter (1) with a few turns using the hex key until the
adapter (1) can easily be moved.
• Position instrument tray (3) in the required height (max. 800 mm above
the floor) and uniformly tighten (2.1 Nm) all four locking screws of
adapter (1) using the hex key.
• When attaching adapter (1), make sure the two components of the
adapter (1) are separated by the same distance (4) from top to bottom.
Carrier arm flat screen monitor
• Hold the carrier arm flat screen monitor with one hand and unscrew the
four locking screws at the adapter (1) with a few turns using the hex key
until the adapter (1) can easily be moved.
• Position the carrier arm flat screen monitor (2) in the required height (max.
1230 mm above the floor) and uniformly tighten (2.1 Nm) all four locking
screws of adapter (1) using the hex key.
• When attaching adapter (1), make sure the two components of the
adapter (1) are separated by the same distance (4) from top to bottom.
NOTE Overload of the instrument tray!
When overloaded, the instrument tray may break off or bend, the suspension
system may topple over and accessories may fall down.
• Make sure that the accessory equipment is positioned as securely as pos-
sible on the instrument tray.
• The instrument tray may be loaded with the maximum weight of 13 kg.