ZEISS
2 Safety | 2.4 Warning and Information Labels
False diagnosis
The visualized images of the camera 8MPx may only be used for training and research. Direct gen-
eration of diagnostic results from these images is not recommended.
Inappropriate
transport
Inappropriate transportation may damage the microscope or cause further material damage. Be-
fore any transportation, switch off the device and let it cool down. Only use the original packag-
ing for storage or transportation. Maintain the transportation and storage temperatures as speci-
fied in Technical Data and Conformity.
Sensitive optics
The microscope contains sensitive optical components. Do not touch optical surfaces. Avoid fin-
gerprints on the surfaces of lenses and light sources.
Unauthorized
manipulation
Using components not certified by the microscope manufacturer and any unauthorized opening
of the device or its components lead to the loss of all warranty claims. Only use microscope com-
ponents supplied by ZEISS. Do not open the device unless you are trained and explicitly authorized
by ZEISS. Always contact ZEISS or a certified service agency for the repair of the instrument.
Inappropriate
disposal
The microscope is not to be disposed of with household waste. Dispose of the device, illumination
bulbs, batteries, the power supply and other components in compliance with the provisions of the
law in force.
2.4 Warning and Information Labels
All points that may pose special risks are additionally marked by warning labels (pictograms) on
the microscope. These warning labels indicate possible dangers. They are part of this instruction
manual. They are to be kept in a clean and legible state. Warning labels that are damaged or no
longer clearly legible must be replaced immediately. Always observe all warning labels on the mi-
croscope.
1
2
3
Fig. 1: Positions of labels on the microscope rear side
4
Fig. 2: Position of the label
Instruction Manual ZEISS Primostar 3 | en-US | Rev. 1 | 415501-7011-111_en
11
