Zeiss OPMI PROergo S7, Instructions For Use Manual

Page: 222 / 268

Care and maintenance S7 / OPMI PROergo
Version 11.0
Page 222 G-30-1435-en
Xenon lamp module, changing
• Please observe the following points:
– First switch off the suspension system at the power switch.
– Only change the lamp module after it has cooled down completely!
In case of malfunction, the high pressure inside the hot lamp may
cause the lamp to burst. The hot surface of the xenon lamp may also
cause burns.
– Tap the key (1). The lamp module is slightly ejected.
– Pull out the lamp module as far as it will go.
– Slide the original transport case (2)over the module, Bolt (3) must
engage in hole (4). This unlocks the stop.
– Remove the old module and install the new lamp module by
proceeding in the reverse order.
CAUTION Risk of injury caused by lamp rupture!
Lamp rupture (audible as a loud bang) may lead to jamming of the lamp
module and/or failure of the electronics modules.
• Before opening the lamp housing, ensure that the device is moved to
a position in which possibly falling particles cannot put the patient or user
at risk.
• Do not continue using the system if the lamp module is jammed or the
illumination is no longer operational due to defective electronic modules.
Contact our Service Department.
NOTE Risk of burns from hot lamp!
If you replace the lamp shortly after it has failed, the lamp will still be very
hot.
• Allow the lamp to cool down before removing it.
• Always use heat-resistant protective gloves when replacing the lamp!
CAUTION Injury caused by improper handling!
Improper handling of the xenon lamp may lead to damage or injury.
• The lamp module may be changed only by appropriately trained
personnel.