Zeiss OPMI PROergo S7, Instructions For Use Manual, Page: 125 / 268

Version 11.0
G-30-1435-en
Page 125
S7 / OPMI PROergo Device overview
Assignment of functions:
Use the (
, ) arrow buttons to select the required function from the table.
Use the ( , ) arrow buttons to select the button required (C or D).
After you have pressed the "Enter" button, a check mark ( ) indicates
that the selected function has been assigned to the selected button.
When you press the "Enter" button again, your selection is saved and you
return to the "Surgery" menu.
Binocular Settings memory function
This menu only has a memory function. It provides sliders which enable each
user to set his/her interpupillary distance and prescription using one of the
arrow buttons (
, ) and to save these values. No motorized setting is made
on the eyepieces or tube.
This function is intended to allow OR staff to adjust the surgical microscope
to the surgeon's settings before the procedure and, if necessary, to retrieve or
change the stored values.
– You can set the interpupillary distance in 1 mm increments from 55 mm
to 80 mm.
– When using widefield eyepieces with a magnetic coupling, you can set
your prescription between –5 D and 8D.
Eyepiece Settings menu
In this menu, you can mark the type of eyepiece (10x or 12.5x) used on the
surgical microscope. This is required for the correct display of the total
magnification provided by the system. Use the arrow buttons (
, ) to
select the eyepiece type. Press the "Enter" key to save the eyepiece type used.
Press the Enter button to save the value set and to return to the Surgery menu.
If you do not press any key, the display will automatically jump back to the
Surgery menu after approx. 30 seconds.
Magnetic Brakes menu
This menu permits you to activate or deactivate the magnetic brakes.
In the "On" mode, the magnetic brakes are active.
In the "Off" mode, the magnetic brakes are inactive.
In this mode, you can adjust the friction of the microscope's axes using the
relevant adjustment knobs.
If "Off" has been activated by pressing the Enter button, the magnetic brakes
will be unlocked and remain unlocked when you press release button(1) the
next time.
To reactivate the magnetic brakes, select "On" and press the Enter button.
The magnetic brakes are now active again, i.e. when you press release button
55 mm
+ 0.00
+ 0.00
10 x
12.5 x
12.5 x
1
On
On