Zeiss OPMI Lumera i, Instructions For Use Manual

Page: 78 / 184

Preparation for use OPMI Lumera i
Version 8.0
Page 78 G-30-1720-en
Connecting the strain relief
Use the strain relief device to prevent the connected cables inadvertently being
pulled out.
Make sure that the remaining cable length between the strain relief device
and the connector (on the connector panel) is approx. 320 mm.
Secure the cable in the strain relief device as follows:
• Form a loop with the cable (2).
• Open flap (3).
• Feed the cable through the opening (4).
• Close the flap (5).
• Tighten the cable until it encloses the flap (6).
• Check the cable length.
Fig. 28: Connecting the
strain relief
1
1 2 3
4 5 6 7
9
320 mm