Zeiss opmi lumera 700, Instructions For Use Manual

Page: 156 / 236

7 Operation Instructions for Use
OPMI LUMERA 700 7.5 Daily operation
156 / 236 G-30-1673-en - 14.0 - 2018-07-12
3. Check the remaining service hours.
4. If the remaining service life is less than 5 hours, the backup
xenon lamp must be swiveled in and the remaining service
hours reset. [
}
193]
7.5.1.3 Setting the main and auxiliary light sources
The following values can be set in 1% increments for the light
sources:
• LED: 2% to 100%
• Xenon: 5% to 100%
• Halogen: 5% to 100%
Action 1. Open the main menu.
2. Tap the [Light] menu button.
3. Tap the [OPMI light] submenu button or the [2nd light source]
submenu button.
ð
The selected submenu will appear.
4. Tab 1: Set the desired light intensity using the arrow buttons.
5. Tab 2: Select an initial state.
6. To temporarily save the settings: tap the button.
7. To save the settings to the surgery profile: tap the
button.
7.5.1.4 Setting filters for the main and auxiliary light sources
Filters [
}
38] can be swiveled in or out to protect the patient's eye.
The filter selection is dependent on the light source installed.
Action 1. Open the main menu.
2. Tap the [Light] menu button.
3. Tap the [OPMI light] submenu button or the [2nd light source]
submenu button.