Zeiss MMZ M, Operating Instructions Manual

Page: 80 / 154

Starting the CMM
6-6
61211-1270302 MMZ M
CMM starting sequence
Proceed in the following order when switching the controller on:
1 Connect the power supply; switch it on with the main switch. [1]
2 Switch the controller on. [2]
3 Activate the ram protection. [3]
4 Turn the drives on. [4]
5 Select the operating mode. [5]
6 Switch the computer on and start the measuring software.
Start-up sequence
Connecting the power supply (1)
– Turn the main switch clockwise to position «1».
The power supply for all electronic components of the CMM is
switched on.
Switching on the controller (2)
1 Turn the rotary switch to the «ON» position.
The indicator lamp of the switch lights up. The controller is on.
2 Wait for approx. 30 s before switching the drives on.
This is necessary because the internal computer of the controller re-
quires a certain amount of time to start. The starting process must
be completed before the drives are switched on. The LEDs on the
control console flash during the starting process.