Zeiss LSM 880, Operating Manual, Page: 407 / 690

CHAPTER 1 - SYSTEM OPERATION
LSM 880 Left Tool Area and Hardware Control Tools ZEISS
10/2014 V_01 000000-2071-464 401
Automatic pinhole adjustment:
The automatic adjustment allows the pinholes to
be used with any combination of beam splitters
and more than one active channel.
Please do not make any program
manipulations while the automatic
pinhole adjustment is running (status
display is red - busy).
•
Click on the
Adjustment Adjust
Automatically button.
−
The
Requirements for Adjustment
window will then appear.
•
Meet the requirements listed in the
Requirements for Adjustment window
(Fig. 559). Press Cancel to abort the automatic
pinhole adjustment. Press the OK button to
proceed.
−
Pinhole adjustment will then run
automatically and the Scan window will
appear (see Fig. 560). The adjusting
procedure takes approx. 3 min.
−
The determined data are stored
automatically and will be available for all
further examinations using the same
configuration.
A change of the pinhole diameter made
manually in the
Pinholes section panel
will update the pinhole diameter in the
Channels
tool and vice versa.
Pinhole adjustment should be done on a
regular basis (monthly, depending on
system usage).
Fig. 559 Requirements for Adjustment
window
Fig. 560 Pinhole adjustment scan window