SAFETY INFORMATION
Lattice Lightsheet 7
Notes on Care, Maintenance and Service
ZEISS
04/2021 V_01
000000-2324-960
21
1.12
Notes on Care, Maintenance and Service
The device manufacturer cannot be held responsible for damage caused by improper use, negligence or
unauthorized intervention in the system, in particular removal or replacement of device components or the
use of unsuitable accessories of other manufacturers. Such actions will render all warranty claims invalid. Nor
can the laser safety be guaranteed.
The microscope computer is a system computer controlling a high-end microscope system.
The computer must not to be used as a general workstation with frequent updates of windows
patches or security patches. The ZEN software is released with a specific windows version and
patch and this must not be changed unless approved by Carl Zeiss Microscopy.
Please contact your ZEISS service representative to check the safety of the device. Please keep the service logs
of your device.
1.12.1
Notes on Maintenance and Care by the Manufacturer Service
To ensure proper functioning of the system in the long term we recommend entering into a service agreement
with your closest ZEISS representative.
You are well advised to arrange a service agreement with your nearest ZEISS representative to guarantee
perfect functioning of the microscope system in the long term.
Use only original spare parts.
Damaged devices or components may only be repaired or replaced by the responsible customer service
representative. Modifications to and retrofitting of system components may only be carried out by the
manufacturer, customer service representative or persons authorized and trained for the purpose by the
manufacturer. Use only original spare parts.
In the event of necessary maintenance or repair work by the service personnel the customer is asked to
remain at a distance and wear laser safety goggles as necessary.
