Zeiss KSK 150 FC, Instructions For Use Manual

Page: 42 / 92

Preparations for use KSK 150 FC
Version 7.1
Page 42 G-30-1158-en
Attaching the equipment
Binocular tube, eyepieces and objective lens, mounting
• Bring the suspension arm to a position convenient for you and tighten the
adjustment knob (6).
• Loosen securing screw (5) by a few turns.
CAUTION Risk of injury caused by parts falling down!
If components and accessories are mounted on or removed from the device
about the patient, which is not allowed, this can cause parts to fall, can cause
injury to the patient, and can cause infections.
• In general, components and accessories should be changed without the
patient, and always before a surgical procedure or examination.
R045
CAUTION Injury to the eye due to light radiation!
R079
Looking into a light source through a tube, an objective lens or an eyepiece
may cause eye injury.
• Never look into a light source or the sun with a tube, an objective lens or
an eyepiece.
CAUTION Risk of injury caused by parts falling down!
R045
R049
R050
R078
R080
Due to collisions or incorrect installation, parts may fall down and injure the
patient.
• Observe the maximum admissible load capacity of the suspension arm.
See the warning label on the instrument head.
• Before every use and after re-equipping the system, make sure that bin-
ocular tube (2) is securely locked in position.
• Make sure that securing screw (5) and objective lens (1) have been firmly
tightened!
• Use adjustment knob (7) to re-adjust the balance of the suspension arm
after every change of the equipment.
• Check that the floor stand is secured in a steady position and can be piv-
oted without causing collisions.