Zeiss KSK 150 FC, Instructions For Use Manual

Page: 40 / 92

Preparations for use KSK 150 FC
Version 7.1
Page 40 G-30-1158-en
Relocating the system
• Turn off the device at the power switch.
• Remove the power plug from the wall socket.
• Bring the device into its moving position, see "transport" sketch. This
sketch is printed on the carrier arm.
• Lock the carrier and suspension arms by means of the friction knob for ro-
tational motion (1).
• Release the locking tabs (2) on the casters by pressing them upwards.
• Do not pull the device by the cables.
• Avoid collisions of any kind.
• To cross thresholds, usually it is sufficient to pull the device in the area of
the lamp housing.
• Do not cross over steps and edges. Risk of toppling!
• Be extremely careful when moving over slopes.
• Do not park the stand on a sloped surface.
• Position the device at its new site of use.
• Tighten the locking tabs (2) on the casters by pressing them downwards.
• Check that the floor stand cannot be moved.
VORSICHT Risk of crushing - mind your fingers!
R067
Fingers may be crushed in the areas marked with the "Risk of crushing" label.
• Do not touch these areas while the system is being moved or brought in
its working / transport position.
CAUTION Risk of injury during transportation!
R062
R064
When transported improperly, the device may topple over or start to move
inadvertently.
• Only move the device to another location with the suspension arm in
transport position.
• The locking tabs on the casters should only be released for transporta-
tion.
• Do not sit or step on the device.