IOLMaster 700
3.3.2
Computer Module & Cover Removal
Precondition:
The computer base covers have been removed.
Procedure:
1)
Remove the two screws (Torx 20) securing
the computer module to the computer base.
2)
Using the tabs slide the computer module
out of the computer base.
Fig. 30 – Computer Module
3)
Disconnect all cables from the rear of the
computer module. A 7mm ring spanner/hex
socket driver is required to remove the
grounding cables (yellow). Pay attention the
MH cable and PI cable must be connected as
shown in
Fig. 31
.
Fig. 31 - USB connection for MH and PI
4)
Remove the three screws (Torx 10 + 8)
securing the cover to the computer module.
5)
Raise the cover and remove. Pay attention
that the cover hinges on the connector side
(power supply, Ethernet, On/Off switch side)
during removal.
6)
Pay attention that the foam rails are not lost
or removed during removal.
Reassembly:
1)
Reassemble in the reverse order.
Fig. 32 - Computer Module Cover removal
MH Cable
PI Cable
Screws
Tabs
Screws
Service Manual
Confidential and Proprietary
SM-30-4060
Order No. 2075-325
3 - 14