22
Corona process | User Manual
Installing the measuring system
Corona process
4.2 Installing the Corona process
The
Corona process
is mounted on a customer interface according to customer-
specific requirements.
The example described below is explained based on the mounting option with
the original mounting device (included in mounting package
000000-2107-066
)
from Carl Zeiss Spectroscopy GmbH.
•
Prepared customer-installed mechanical interface with four M8 threaded
holes or four through holes with a diameter of 9 mm for fastening the
mounting device.
For the connection dimensions of the mounting device, please refer to the
illustration below.
Fig. 7
9
50
25
80
100
t
=
13
50
70
Connection dimensions of the mounting device
•
Four M8 fastening screws for attaching the mounting device to the customer
interface in the length required on-site and with suitable retaining elements
for the fastening screws (e.g. toothed lock washers)
•
Tools depending on the type of screw (not included in the scope of supply),
e.g.:
– Open-end wrench, 13 mm A/F
– Allen key, 6 mm A/F
– Screwdriver, TX25
Requirements
