Zeiss CONTURA, Operating Instructions Manual

Page: 45 / 158

Components and function
61211-1310402 CONTURA
3-9
that allows you to mount the legs as needed. There is an additional
groove on the side of the guide profile that allows you to connect a
mounting bracket.
Mounting bracket Mounting brackets are an optional alternative for fastening the rack to
the measuring table. Mounting brackets are preferred when the changer
rack needs to be mounted in the Y axis and insufficient space is available
for this purpose in the X axis.
Mounting bracket [1]
Frame supports
The profile rails are mounted on the frame supports. Spacers are pro-
vided for this purpose.
ProMax E changer rack (option)
ProMax E is a changer rack with movable stylus system holders. Depend-
ing on the changer rack version, either single holders or profile rails with
several holders can be moved.
The changer rack offers the advantage that the entire measuring range
can be used for measurements. The changer rack is mounted outside
the measuring range. During stylus system change-out, the selected
holder moves into the measuring range. Once the new stylus system has
been installed, the holder moves again out of the measuring range.
An electrically driven linear module is used for moving the holders.
NOTE
Separate operating instructions are available for ProMax E. These oper-
ating instructions contain detailed information on the changer rack.
Installation
NOTE
Three threaded bushings are provided on the rear of the measuring ta-
ble. These threaded bushings are used to attach the changer rack.
See also