Components and function
3-6
61211-1310402
CONTURA
Y axis (columns)
The drive-side and guideway-side columns support the X-bridge cross-
beam and the frictionless air bearings allow moving the entire bridge
in the Y axis.
Z axis (ram)
The ram is guided in the Z bearing cage. It can be moved in the
verti-
cal
direction and is used to probe in the Z axis. The probing system is
located at the bottom of the ram.
Reference standard
A high-precision sphere is used as the reference standard. The sphere is
made of ceramic and has a diameter of 30 mm. The sphere is attached
to a reference sphere holder.
Reference sphere with shaft
The shaft of the reference sphere can be screwed in at different posi-
tions of the reference sphere holder. It is possible to mount more than
one reference sphere onto the reference sphere holder.
Note:
Addi-
tional reference spheres have to be installed by a ZEISS service engineer.
Reference sphere holder RSH 214
1 Reference sphere
2 Reference sphere shaft
3 Reference sphere holder
Service unit for compressed air supply
Some components of the CMM require compressed air. The service unit
is located on the rear side of the CMM.
Summary of Contents for CONTURA
