Zeiss CenterMax, Operating Instructions Manual

Page: 118 / 166

7-18
Measuring operation
61211-1020202 CenterMax Operating Instructions
– Master probe
The master probe must be used for the reference measurement
➤
“Carrying out a reference measurement” on page 7-19 .
– Probes used for workpiece measurement.
Prerequisites for perfect calibration
Before you start calibrating, make sure that the following prerequi-
sites are met:
– The probe is stable.
– All probe components are screwed together firmly.
– The limiting values for the probe design are observed.
– The calibration sphere, probe elements and adapter plate are clean
and not damaged.
– Probe components are not damaged.
Mounting the calibration standard on the measuring
table
Since the calibration standard has a magnetic base, it must be placed
on a metal plate so that the magnet can act. A metal plate must
therefore be screwed onto the measuring table.
1 Rotary lever for activating the magnet
2 Metal plate with through holes
3 M12 threaded hole in the measuring table
4 Example of position of metal plate (for mounting calibration standard).