24
Changing the motor
AURA
®
handheld NIR - Rev. 2
Maintenance and Repair Manual | AURA
®
handheld NIR - Rev. 2 | EN_40_070_0030I
10
Install motor holder
Caution
SENSITIVE COMPONENTS
When installing the motor holder with white reference assembly, ensure
that the motor cables are handled very carefully.
Insert the motor holder
1
with cables and the white reference into the
front panel
2
.
Fasten the motor holder with the two Torx screws
5
, at first only loosely,
to the front plate
2
. Use a TX 8 Torx screwdriver for this.
Fig. 21
=
1
3
4
2
7
6
5
Install motor holder
Note
NOTE REGARDING ASSEMBLY
During assembly, make sure that the white reference assembly
3
has the
same clearance
7
on the right and left to the inner plate
6
.
When you have aligned the white reference assembly (see clearance
7
),
tighten the two clamping screws
4
of the motor holder to lock the motor.
Then tighten the two Torx screws
5
to lock the motor holder
1
.
Now check if the white reference can move through the inner plate of the
front panel without catching. If not, realign by adjusting the clamping screws
of the motor as well as the screws fastening the motor holder to the front
panel.
