Zeiss 000000-1080-349, Instructions For Use Manual

Page: 217 / 278

Version 7.0
G-30-1781-en
Page 217
S100 / OPMI pico What to do in the event of malfunctions
Lamp failure of halogen light source
The lamp housing contains a backup lamp which can be manually swung into
the illumination beam path when the first lamp fails. Open flap (1) indicates
that the backup lamp is operative.
• Press button (2) to manually swing the backup lamp into the beam path.
 Open flap (1) indicates that the backup lamp is operative.
• Replace the defective lamp at the first opportunity (see Page 224).
• If the backup lamp is defective and replacement is not possible, continue
surgery using an external OR illuminator.
Fig. 98: Swing in the
backup lamp
CAUTION Risk of burns!
In the event of overheating, the lamp switches off automatically. When the
lamp has cooled down, it automatically switches on again.
If the microscope is positioned unattended above the patient, the patient can
be burnt due to the produced heat.
• Immediately activate the backup lamp after a lamp failure or switch off
the light source completely.
• Check if the light source is switched off before leaving the device unat-
tended.
1
2