zebris Medical GmbH
FDM-T Technical Data and Operating Instructions
Page 40/65
5
Gait Training Module
For the gait training and the feedback training (virtual Forestwalk) a projector unit (beamer)
can be mounted to the treadmill frame. In order to accomplish adapters individually engi-
neered for different treadmill types are necessary. The assembly of the available adapter
types is described below.
NOTE
For setup, installation and safety related instructions of the projector
please refer to the user manual of the projector manufacturer.
The projector is connected directly to the corresponding hardware interface (mostly HMDI
or DVI). The projection during gait training is controlled by the gait training module of the
zebris FDM software.
WARNING
During long periods of operation, the projector can become very hot
in the area of the lamp and at the air outlet openings and thus
should not be touched.
WARNING
In order to minimise the risk of falling and to prolong the lifetime of
the projection lamp, the projector should only be switched on during
the gait training and otherwise be switched off.
WARNING
With treadmills featuring an inverse driving direction, the projector
must be separated from the mains before activating the inverse driv-
ing direction.
As with installed projector and activated inverse driving direction a
higher risk of injury through falling exists because of the projector, a
safety (safety bow with chest strap) should always be used with
treadmills featuring an inverse driving direction.