zebris Medical GmbH
FDM Technical Data and Operating Instructions
Page 5/36
1.5 Personal safety, warnings and prohibitions
General safety instructions
The operating instructions constitute an integral part of the FDM device and are to be
kept readily available for all the users at all times, and/or in easy reach of the device.
The exact observance of the operating instructions is a prerequisite for the intended use
of the device.
User safety and adherence to the given measuring accuracy are only guaranteed if the
expendable items described in the operating instructions are used.
The application and operation of the system and also the evaluation of the measuring
data and their interpretation may only be carried out by trained qualified personnel. The
manufacturer assumes no liability for any injury to persons, damage to property, or loss
of data due to improper use of the software, the device or its components.
The safety, reliability and function of the device can only be guaranteed if
a) repairs are carried out by authorized zebris personnel
b) the room for the installation conforms to the valid installation regulations
c) the device is used in conformity with the operating instructions.
Only operate the device using the stipulated mains voltage and the power supply unit
delivered with the measuring system.
Do set up the platform near a source of heating or in direct sunlight in front of a window
as a rise in temperature can lead to inaccurate measuring results.
If any fluids should penetrate the device, it is mandatory for the device to undergo a
technical, safety test. Damaged plug connections and leads are to be replaced by an
authorized service technician.
Never insert any objects in the components of the measuring system.
Should any malfunctions and/or defects be determined or suspected, it is mandatory for
the de
vice to be put out of operation immediately, marked as "Not working“ and
prevented from being used by removing the mains cable.
Be sure that all the mains and connection cables are laid safely and that they are
protected against stepping on, so that nobody can trip over them. Check all the cables
and the connection plug regularly for any damage.
Should malfunctions and/or defects be determined or suspected, the device must be put
out of operation immediately, marked as "Not working“ and prevented from being used
by removing the mains cable.
Should one of the situations in the following list occur, please do not fail to contact the
manufacturer or the distributor authorized by zebris:
a) The mains cable or mains plug has been damaged
b) Fluid has been spilt over the main device or other system components
c) The system fails to function perfectly, despite adherence to the operating instructions
d) The housing or other system components has/have been damaged.
Repairs, maintenance and new adjustments have to be done only by authorized and
trained personnel. Storage and transport take place only in the original packaging.
If the type plate or other important labels (warning notices) are damaged or obliterated
they have to be replaced by the manufacturer for safety reasons.
