Handheld Bluetooth® CCD/Laser Scanner
11
U
SER
’
S
M
ANUAL
Note:
In cradle host mode, the scanner is always in master mode and cradle is in slave
mode. Therefore, you have to scan on “Unlock Pairing Mode” barcode symbol to
unlock paired scanner and cradle, than connect or link to other devices.
6.
As the scanner links to the communication cradle, the cradle LED stays in BLUE. If
in any case the scanner link timeout or enters power down mode, then the cradle
LED flashes in BLUE. Press scanner trigger or place the scanner back into the cradle,
the communication links automatically again.
Note:
The default radio communication type of scanner sets in cradle host, if by any chance the
scanner lost this setting, use the programming barcode symbologies provided in this
booklet to set it as “Cradle Host” again.
SPP - Slave
In the mode of SPP Slave, the scanner is remote by connecting with Serial Protocol Profile
(SPP) host. Therefore, please first make sure your host device is well equipped with
advanced wireless technology connectivity and an application software before following
the steps below to start pairing.
Note:
All host device and application software has different operating features, here we take a
Widcomm BTW utility as an example.
1.
Turn on the host computer and activate its Bluetooth® connection.
2.
Scan “Start of Configuration” to enter programming mode
3.
Scan “SPP Slave” barcode label
4.
Scan “End of Configuration” barcode label to exit programming mode. Now, the
scanner LED flashes in GREEN, indicating it’s waiting to be connected.
5.
In the host computer, execute the discovering procedure and find the scanner, it is
always shown as “ZBBT” as device name (Shown in Figure 3-2).