Solo documento principale.
Ident
ific
at
ion:
M
D
-AL
-GI
-00
R
ev
. 4
.0
of
31.
01.
18
–
A
ppl
ic
at
ion:
G
ID
Pile Reg. IT12110P00002965 -
Share Capital € 100,000.00 fully paid up
AR Bus. Reg. no. 03225010481
– AR REA no. 94189
ISO 9001 Certified company - Certificate no. 9151 - CNS0 - IT-17778
Zucchetti Centro Sistemi S.p.A. - Green Innovation Division
Via Lungarno, 248 - 52028 Terranuova Bracciolini - Arezzo, Italy
tel. +39 055 91971 - fax. +39 055 9197515
[email protected] - [email protected] -
zcsazzurro.com
Manual of 25/05/2020 Rev. 1.0 “User Manual 22K-BE-24”
39/44
Figure 37 - Plug&Play mode
8.
Operation
8.1.
Connecting the charger to the electric vehicle
Position the electric vehicle near the charger, making sure the cable is not taut.
1)
Pull out the battery-charger cable from the electric vehicle and connect the charger and electric
vehicle connectors.
2)
Check that the connectors are positioned correctly and secured properly. When properly connected,
the LED on the charger should flash yellow, indicating that the charger is ready to charge the vehicle.
8.2.
Start of charging
After the connector has been connected to the electric vehicle and is ready to charge, scan the RFID
card (depending on the mode selected) once on the identification area of the front panel in order to
start the charging operation.
When charging starts, the connector will be secured to the socket, until otherwise instructed; the
charger will display real-time information on the charging status, such as electricity supplied, charging
time, voltage, current and power.
