Zaxcom ZMT4 Flex Record Menu
12
Time Left on Card
This menu will only appear if a card was inserted prior to booting up
This page displays the remaining record time left on the card as well as the time already recorded on the card.
Automatic Record after Boot up
Record on boot up allows the onboard recorder to automatically start recording after the ZMT4 Flex boots up.
•
ON
- The onboard recorder will automatically start to record after the ZMT4 Flex boots up.
•
OFF
- The onboard recorder will wait for a ZaxNet command or a manual record trigger to start recording.
Low Battery Stop Set
Low battery stop will set the amount of time, after a low battery warning occurs, the on-board recorder will
close the current file and stop recording.
This is to prevent possible file corruption if the unit constantly powers off and on due to a dead battery.
•
NEVER STOP
- The onboard recorder will not stop recording unless it is manually stopped by a key press, or
when it receives a stop command via ZaxNet, or if the battery dies.
•
Any interval from 1 to 99 minutes
- Once the battery indicator starts blink a low battery warning the
onboard recorder will continue to record for the time set here - then it will close the file and stop
recording.
TIME LEFT 20 H
TIME USED
4 H
RECORD ON BOOTUP
OFF
LOW BATT STOP:
NEVER STOP