Zaxcom RX-8 Main Menu
8
Transmitter Gain
This menu will only appear when allow transmitter remote is turned on in the extended menu.
•
Pressing the INC key will remotely increase the gain of the transmitter being received.
•
Pressing the DEC key will remotely decrease the gain of the transmitter being received
•
When the gain is being adjusted “+++” will appear when the gain is being increased and
“- - - -“ will appear when the gain is being decreased. The gain value of the transmitter will be shown.
•
If the receiver is in dual mode press the RX key to select the desired receiver.
Unit Code
This menu will only appear when allow transmitter remote is turned on in the extended menu.
This is where the unit code is set. The unit code needs to match the unit code of the transmitter that the MRX
is receiving. Pressing the RX key will toggle between receivers.
Please note the group code is set on the ZaxNet sending device either a camera link or IFB.
Test Tone Output
From the tone menu a 1K test tone can be enabled. This is used to set levels and check routing.
Pressing the INC and DEC key will cycle through the different tone settings.
•
OFF -
No tone is being outputted.
•
-20dBFS -
Tone is simultaneously sent to all 4 outputs at -20dBFS.
•
+0dBFS -
Simultaneously sends tone to all 4 channels at 0dBFS (full scale).
TX A 18
GAIN
RXA > UNIT : 1
RXB UNIT : 2
TONE:
OFF