Zauber ECO-250, Manual

Page: 18 / 44

Zauber ECO-250 © ZAU Grupp 2012 (ENG) Page 18 of 44
cleaners to scrape the soleplate.
2. Clean the upper part of iron with a soft damp cloth.
Wipe the water drop on the steam generator and the
thermal insulating cushion with dry cloth.
3. To remove the mineral deposits collecting at inner
steam generator, firstly put the iron horizontally on a level
surface, then tilt the steam generator and unscrew the
drain water cap with the attached screwer, and then drain
the steam generator.
WARNING: To avoid a risk of scald, make sure the steam
generator has been cooled down completely before
unscrewing the drain water cap.
4. After drainage, screw the drain water cap tight and
recover the steam generator standing.
5. When do not use the appliance for a long time, pour out
the water in the tank, and store the iron on the thermal
insulating cushion.
6. Wind the steam supply hose and power cord around the
cord winding groove and secure it by the cord clamps.
Ironing tips
• Always check first whether a label with ironing
instructions is attached to the article. Follow these ironing
instructions in any case.
• The iron heats up quicker than cooling it down,
therefore, you should start ironing the articles requiring
the lowest temperature such as those made of synthetic
fiber.
• If the fabric consists of various kinds of fibers, you
must always select the lowest ironing temperature to iron
the composition of those fibers.
• Silk and other fabrics that are likely to become shiny
should be ironed on the inner side. -Velvet and other
textures that rapidly become shiny should be ironed in
one direction with light pressure applied. Always keeps
the iron moving at any moment.
• Pure wool fabrics (100% wool) may be ironed with
the steam iron. Preferably set temperature dial to the
maximum position and use a dry cloth as a mat.
• Never iron over zip, rivet in the cloth. This will damage
the soleplate. Iron around any such object.
NOTE: When ironing woolen fabrics, shining of the fabric
may occur. So it is suggested that you should turn the
article inside out and iron the reverse side.