Zauber ECO-220 Hemmafru, Manual

Page: 14 / 36

Zauber ECO-220 © ZAU Grupp 2012 (ENG) Page 14 of 36
• Put cloth between tire and brush.
Tightly close the handle around the cloth and iron from
top downward. Before dismounting the brush again,
switch the device off. If no steam is coming from the
brush, it may be removed. Never touch the elements
made of stainless steel, it may lead to burns.
Storage
• After completion of operation, remove the water tank
from the main device and empty it.
• Switch on the device for 5 minutes in the drying mode
to dry it.
• Switch off the device (operation indicator fades out).
Remove the plug from the socket and press the cord
folding button to put the cord in the device casing.
• Warning: Do not touch the brush until it completely
cools. Before displace the device, wait until it gets cold
completely.
Cleaning
• Wipe the casing with wet duster. To keep the device in
good condition, clean it from scale on a regular basis.
Periodicity of such cleaning depends on use frequency.
Water tank shall be cleaned from scale at least once a
year or in every 100 hours of operation. Adhere to the
following instructions:
- Dismount the water tank and wash scale with fresh
water.
- Unlock the handle in the lower part of the tank to
discharge water and then wash it with fresh water
again. Figure 9
Should any scale remain after the above operation,
follow these instructions again.
Trouble shooting
Problem Cause Solution
The security device does
not work
One of the circuits has
fault, the plug is loose,
the fuse burned, the
LED of supply source is
extinguished
Check and maintain by
specialized technician
A noise originates pipe of
steam but the produced
steam is weak
The pipe is twisted
below level to iron
Raise the steam pipe
(residual water in top
returns into the device)
5