23
3.5.2.2
G85 Standard cycle of orbiting around a circle
L
–
The number of convolutions
S
–
Stroke
D
–
Diameter of orbiting
Presented below is a program that carries out a orbit of 5mm in diameter, machined to the depth of 8mm:
%
G56
G00 X0 Y0 Z0 A0
G85 L8 S1 D5
%
3.5.2.3
G86 Standard cycle of orbiting around a square
L
–
The number of convolutions
S
–
Stroke
D
–
The length of an orbit side
Presented below is a program that carries out a orbit with a 5mm-long side, machined to the depth of 8mm:
%
G56
G00 X0 Y0 Z0 A0
G85 L8 S1 D5
%
3.5.2.4
G90/G91 Modifying the method of interpreting data
(absolute/incremental)
Presented below are programs that carry out drilling to the depth of 2mm:
Absolute (G90):
Incremental (G91):
G56
G90
G00 X0 Y0 Z0 A0
G01 Z-2.0
G01 Z0.0
G56
G91
G00 X0 Y0 Z0 A0
G01 Z-2.0
G01 Z+2.0
3.5.3
M-Codes
Table 3.4. A list of the available M-codes
M33
activation of burning detection
M34
deactivation of burning detection
M35
activation of vibrations
M36
deactivation of vibrations
M37
activation of the
“
Extended Automatic Working Mode
”
M38
deactivation of the
“
Extended Automatic Working Mode
”
