To display the refrigerator or freezer temperature, push
the temperature selection button once or twice, respec-
tively.
The temperature display can show also:
• The medium temperature inside the refrigerator after
pressing the Temperature selection button (refrigerator
compartment indicator is on), for a while.
• The highest temperature inside the freezer after press-
ing the temperature selection button twice (freezer
compartment indicator is on), for a while.
• Fridge temperature set (value is blinking) when the
Fridge temperature regulator is adjusted and for a while
afterwards.
• Freezer temperature set (value is blinking) when the
Freezer temperature regulator is adjusted and for a
while afterwards.
Display background colour
By default the display background is blue.
While whatever button or knob is used the background
turns bright blue and remains so for a while.
The display background turns red, if the temperature in-
side the freezer is too warm (alarm). If this is the case, the
temperature display shows blinking the warmest temper-
ature inside the freezer, the Excessive temperature indi-
cator flashes and an acoustic alarm signal is shown.
The temperature might be too warm in the following cases:
• immediately after switching on
• the freezer door was left open for a longer time
• there is an operating trouble in the freezer.
To switch the alarm sound off press Alarm reset button.
The display returns to showing the ambient temperature,
however the background remains red until the freezer
cools down properly.
Should you press no button during alarm, press Alarm
reset button when the sound finishes to see the warmest
temperature reached during the alarm.
Temperature regulation
The temperature is automatically regulated.
Temperature of the refrigerator and freezer can be set by
temperature regulation, respectively. The set temperature
is seen blinking on the display.
For everyday use medium setting, i.e. +5 °C in the re-
frigerator and colder than –18 °C is the freezer is recom-
mended.
Allow the appliance to run for a period of 24 hours when-
ever the temperature setting is changed. This will allow
the temperature to stabilise inside the appliance.
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Shopping mode
Before putting a bigger amount of food into the refrigerator
(e.g. when returning from shopping) press the Function
button once or twice as occasion requires to obtain shop-
ping (the shopping mode indicator shown on the display).
In this manner the refrigerator reaches its lowest possible
temperature to cool down the bigger amount of food.
To exit from shopping mode press the Function button
again. Should you not do so, after a while the refrigerator
returns to automatic mode.
Fast Freezing function
You can activate the Fast Freezing function by pressing
the Function button once or more times until the Fast
Freezing indicator is shown on the display.
It is possible to deactivate the function at any time by
pressing the Function button again until the Fast Freezing
indicator goes off.
First use
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm water
and some neutral soap so as to remove the typical smell
of a brand-new product, then dry thoroughly.
Important! Do not use detergents or abrasive powders,
as these will damage the finish.
29
