Zanussi ZOP37972, User Manual

Page: 20 / 28

and the bars of the heat indicator until
the door unlocks.
To stop Pyrolysis before it is completed,
turn the knob for the oven functions to the
off position.
6. When Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked.
7. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
Cleaning reminder
To remind you that the Pyrolysis is necessary,
PYR flashes in the display for 10 seconds after
each activation and deactivation of the
appliance.
The cleaning reminder goes out:
• after the end of the Pyrolysis
function.
• if you press and at the
same time while PYR flashes in
the display.
Cleaning the oven door
The oven door has three glass panels.You can
remove the oven door and the internal glass
panels to clean them.
The oven door can close if you try to
remove the glass panels before you
remove the oven door.
CAUTION!
Do not use the appliance without the
glass panels.
Open the door fully
and hold the two
door hinges.
1
Lift and turn the
levers on the two
hinges.
2
Close the oven door
halfway to the first
opening position.
Then pull forward and
remove the door from
its seat.
3
Put the door on a soft
cloth on a stable
surface.
4
Release the locking
system to remove the
glass panels.
5
90°
Turn the two
fasteners by 90° and
remove them from
their seats.
6
2
1
First lift carefully and
then remove the
glass panels one by
one. Start from the
top panel.
7
Clean the glass panels with water and soap.
Dry the glass panels carefully.
When the cleaning is completed, install the
glass panels and the oven door. Do the above
steps in the opposite sequence.
Make sure that you put the glass panels (A and
B) back in the correct sequence. The middle
panel (B) has a decorative frame. The screen-
printing zone must face the inner side of the
door. Make sure that after the installation the
surface of the glass panel frame (B) on the
20 www.zanussi.com