Setting and changing the time
You must set the time before you operate the
oven.
The flashes when you connect the appliance
to the electrical supply, when there was a
power cut or when the timer is not set.
Press the or to set the correct time.
After approximately five seconds, the flashing
stops and the display shows the time of day you
set.
To change the time of day press again and
again until starts to flash.
Setting the DURATION
1. Set an oven function and temperature.
2. Press again and again until
starts to
flash.
3. Press or to set the DURATION time.
The display shows
.
4. When the time ends,
flashes and an
acoustic signal sounds. The appliance
deactivates automatically.
5. Press any button to stop the acoustic
signal.
6. Turn the knob for the oven functions and
the knob for the temperature to the off
position.
Setting the END
1. Set an oven function and temperature.
2. Press again and again until
starts to
flash.
3. Press or to set the time.
The display shows
.
4. When the time ends,
flashes and an
acoustic signal sounds. Press any button to
stop the signal.
5. Turn the knob for the oven functions and
the knob for the temperature to the off
position.
6. The appliance deactivates automatically.
Setting the TIME DELAY
1. Set an oven function and temperature.
2. Press again and again until
starts to
flash.
3. Press or to set the time for
DURATION.
4. Press .
5. Press or to set the time for END.
6. Press to confirm.
Appliance turns on automatically later on, works
for the set DURATION time and stops at the set
END time. At the set time an acoustic signal
sounds.
7. Turn the knob for the oven functions and
the knob for the temperature to the off
position.
8. The appliance deactivates automatically.
Setting the MINUTE MINDER
1. Press again and again until starts to
flash.
2. Press or to set the necessary time.
The Minute Minder starts automatically after 5
seconds.
3. When the set time ends, an acoustic signal
sounds. Press any button to stop the
acoustic signal.
4. Turn the knob for the oven functions to the
off position.
Cancelling the clock functions
1. Press the again and again until the
necessary function indicator starts to flash.
2. Press and hold .
The clock function goes out after some
seconds.
Using the accessories
WARNING!
Refer to Safety chapters.
Inserting the accessories
Wire shelf:
8
www.zanussi.com
