Zanussi ZNFE18ES3, User Manual

Page: 15 / 56

Problem Possible cause Solution
There is too much condensed
water on the rear wall of the re-
frigerator.
Door was opened too fre-
quently.
Open the door only when nec-
essary.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
Stored food was not wrapped. Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Water flows inside the refriger-
ator.
Food products prevent the wa-
ter from flowing into the water
collector.
Make sure that food products
do not touch the rear plate.
The water outlet is clogged. Clean the water outlet.
Water flows on the floor. The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The FastFreeze function is
switched on.
Switch off FastFreeze function
manually, or wait until the func-
tion deactivates automatically
to set the temperature. Refer
to "FastFreeze function" sec-
tion.
The temperature in the appli-
ance is too low/too high.
The temperature is not set cor-
rectly.
Set a higher/lower tempera-
ture.
The door is not closed correct-
ly.
Refer to "Closing the door"
section.
The food products' tempera-
ture is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are stored
at the same time.
Store less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened of-
ten.
Open the door only if necessa-
ry.
The FastFreeze function is
switched on.
Refer to "FastFreeze function"
section.
There is no cold air circulation
in the appliance.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and tips" chap-
ter.
15