8. Fit the door in place on the hinge pin.
9. Slot the hinge pin into the hole in the hinge
plate and relocate the hinge assembly to
the opposite location and refit using the
retaining screws.
10. Refit the bottom hinge plate assembly on
the opposite side, taking care that the edge
of the door is parallel with the side of the
cabinet.
11. Remove and install the handle (if foreseen)
on the opposite side.
CAUTION!
Reposition, level the appliance, wait
for at least four hours and then
connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the
gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.
Electrical connection
• Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not
observed.
• This appliance complies with the E.E.C.
Directives.
Technical information
Technical data
Height
mm
850
Width
mm
550
Depth
mm
612
Rising time
Hours
22
Voltage
Volts
230 - 240
Frequency
Hz
50
22
www.zanussi.com
Summary of Contents for ZFT11114WA
Page 47: ...www zanussi com 47 ...
