Zanussi ZDF4013, User Manual

Page: 13 / 16

Problem Possible cause Possible solution
The quantity of detergent was too much. Make sure that you add the correct quan-
tity of detergent in the dispenser before
you start a programme.
Dry water drop stains on
glasses and dishes.
The released quantity of rinse aid was
not sufficient .
Increase the released quantity of rinse aid.
The quality of the detergent can be the
cause.
Try a different brand of detergent.
The dishes are wet. The programme had no drying phase. Set a programme with the drying phase.
The dishes are wet and matt. The rinse aid dispenser is empty. Make sure that there is rinse aid in the
rinse aid dispenser.
The quality of the rinse aid can be the
cause.
Try a different brand of rinse aid.
The quality of the combi detergent tab-
lets can be the cause.
• Try a different brand of combi deter-
gent tablets.
• Activate the rinse aid dispenser and
use the rinse aid together with the
combi detergent tablets.
Activating the rinse aid dispenser with the multitab
function activated
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to ‘SETTING AND STARTING A PROGRAMME’.
3. Press and hold function buttons (B) and (C) at the
same time until the indicators above function buttons
(A), (B) and (C) flash.
4. Press function button (B) .
• The indicators above function buttons (A) and (C)
go off.
• The indicator above function button (B) continues
to flash.
• The display shows the setting of the rinse aid dis-
penser.
Off
On
5. Press function button (B) to change the setting.
6. Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse aid.
8. Fill the rinse aid dispenser.
Technical information
Dimensions Width / Height / Depth (mm) 600 / 850 / 610
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2) max. 60 °C
13
www.zanussi.com