14
The Oven Door and its gasket
Before cleaning the oven door, we recommend you to
remove it from the oven.
Proceed as follows:
1.
open the oven door completely;
2.
find the hinges linking the door to the oven (see
picture 1);
3.
unlock and turn the small levers located on the two
hinges (see picture 2);
4.
handle the door by its left- and right-hand sides,
then slowly turn it towards the oven until it is half-
closed (see picture 3);
5.
gently pull the oven door off its site (see picture 3);
6.
place it on a steady plan.
Clean the oven door glass with warm soapy water and a
softh cloth only. Never use harsh abrasives.
Once the cleaning is carried out, refit the oven door,
following the procedure in reverse.
DO NOT
clean the oven door while the glass
panels are warm. If this precaution is not observed
the glass panel may shatter.
If the door glass panel becomes chipped or has
deep scratches, the glass will be weakened and
must be replaced to prevent the possibility of the
panel shattering. Contact your local Service Centre
who will be pleased to advise further.
Models in stainless steel or aluminium:
We recommend to clean the oven door using only a wet
sponge and dry it up after cleaning with a soft cloth.
Never use steel wool, acids or abrasive products as they
can damage the oven surface.
Clean the oven control panel following the same
precautions.
The correct operation of the oven is ensured by a gasket
placed round the edge of the oven cavity.
• Periodically
check
the condition of this gasket. If
necessary, clean it without using abrasive cleaning
products.
• If the gasket shows to be
damaged
, call you local
Service Centre. Do not use the oven until it has been
repaired.
1
2
3
Lid cleaning
All the cooker lids can be disassembled, to allow a
better cleaning.
The crystal lid can be dissasembled as shown in the
diagram.
Clean the crystal lid only with warm water and avoid the
use of rough cloths or abrasive substances.
After a proper cleaning, carefully reposition the lid
into its hinges.
Balancing the lid
Appliances provided with crystal lids are equipped with
specially balanced springs, inserted in the hinges at the
back of the appliance, to allow the lid to be closed
smoothly and easily.
You can use a screwdriver to adjust the closure of the
lid. The necessary force for opening/closing the lid can
be increased by turning the adjusting screw 2 or 3 times
as shown in the diagram.
