Burner overview
A
B
D
G
E
C
F
H
I
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple
E) Hob
F) Slots
G) Burner body
H) Location peg
I) Hole
Ignition of the hob burners
Always light the burner before you
put on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
1. Turn the knob for the hob to the position
and push it down. When you push the knob,
the spark generator activates automatically.
2. Keep the knob for the hob pushed for equal
or less than 10 seconds to let the
thermocouple warm up. If not, the gas
supply is interrupted.
3. Adjust the flame after it is regular.
WARNING!
Do not keep the knob pushed for
more than 15 seconds. If the burner
does not light after 15 seconds,
release the knob, turn it into the off
position and try to light the burner
again after minimum 1 minute.
If after some tries the burner does
not light, check if the crown and its
cap are in the correct position.
In the absence of electricity you can
ignite the burner without an
electrical device. In this case
approach the burner with a flame,
push the relevant knob down and
turn it to maximum position. Keep
the knob pushed for equal or less
than 10 seconds to let the
thermocouple warm up.
If the burner accidentally goes out,
turn the knob to the off position and
try to light the burner again after
minimum 1 minute.
The spark generator can start
automatically when you switch on
the mains, after installation or a
power cut. It is normal.
Replacing burner parts
1. Put carefully the burner crown on the burner
body. Let the crown fall freely onto the
body. Do not use force.
Make sure that the hole in the crown is
above the ignition candle.
Make sure that the location pegs are in the
slots in the burner body.
Make sure that you can move the crown a
small distance from side to side.
2. Put the burner cap centrally on top of the
crown (enamel side up).
Make sure that the cap is correctly installed
and you can move the cap from side to side
and front to back.
3. Try to light the burner.
If the burner does not ignite, adjust the crown
and cap again.
8
www.zanussi.com
Summary of Contents for ZCG43330BA
Page 1: ...EN ZCG43330BA ZCG43330WA ZCG43330XA User Manual Cooker GB IE ...
Page 25: ...www zanussi com 25 ...
Page 26: ...26 www zanussi com ...
Page 27: ...www zanussi com 27 ...