Zanussi LIBERO IWOKEC-1P/1ZT, Service Manual

Page: 35 / 75

35
LIBERO LINE WOK INDUCTION
The temperature sensor is located at the center of the coil; if the temperature is spiking over set point of max
temperature (260° ) the safety sensor will slowly cut down the power of the generator, if the temperature of the
surface does not go down and it reaches 280C° the sensor will input to shut down the Generator.
There is no manual resetting of the temperature sensor, this because it is electronically controlled; once that
the appliance has cooled down (the appliance will keep in function the ventilation system in case of safety
temp. activation) the appliance will turn back on and restart functioning.
In case of overheating an alarm will be displayed on the U.I. § ALARM CODE LIST
USER BOARD, U.I
BP01 is the power supply connector / XC01 is the
communication cable (U.I to Generator).
Refer also to the EWD at ELECTRIC WIRING DI-
AGRAM (EXAMPLE)
4.6 INDUCTION POTS, PRECAUTIONS
All wok pans must be designed to be used on induction appliances; generally, all are branded with the indicated
logo on the bottom.
Use pans with rounded bottom in iron, iron plate, enam-
eled iron, cast iron, special multilayer metal.
Do not use pots in layered metal with aluminum body
and open edge.
The heating system will not work with unsuitable mate-
rials; these are: nickel chromium, S/steel, aluminum,
copper, brass, glass, porcelain.
To avoid compromising inductor functionality, never use pots with bottoms that are not perfectly flat: the tem-
perature may not be measured correctly, this because the temperature sensor is at the center of the coil and
it needs to “sens” the pans temperature and be in contact with it.
Do not use empty pots or pans on the appliance as they can quickly (in a few seconds) reach very high tem-
peratures.
NOTE !
the temperature probe and coil are part of the generator assembly and not available as single spare
parts.