OPERATION
23
Synthesis
06/40V GAS
5.4.3 Programming of switching on
To enter the setting mode for the programmed switching on,
press and immediately release the key
with the oven on
or off.
At first the state of the automatic switching on (active or inactive)
appears on the display (AUTOSTART : ON or OFF).
To enable or disable the program must act respectively on the
ignition keys to increase and to decrease (Fig. 2).
Once enabled, pressing the enter button is displayed on the
first day of the week and the figures for the hours and minutes
(Fig.3).
To select when to switch the cursor flashing in the figures for
hours using the enter key and then pressing the buttons to
increase and decrease, you set the value (Fig. 4).
If you want the oven does not turn on a specific day (eg, closing
day), during the time setting, select 'Off lying between the 23 and
00 using the keys to increase and decrease (Fig. 4).
Pressing the ENTER button again will switch to minutes and then
pressing the ENTER button again will return the cursor under the
day of the week (Fig.3). To move to the next or previous to press
the buttons to respectively increase and decrease.
Whn completed the setting, press again the enter button and wait
about five seconds. Data is automatically stored and you return
to the previous function.To indicate that the ignition has been
enabled, the display shows idle state the date and time of the
next time (Fig. 5). If the ignition is turned off, instead of the
day and time the message appears "off".
1
3
2
4
5
