ZANKER ZKF680, User Manual

Page: 18 / 52

A
B
C
D
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple
Warning! Do not keep the control knob pushed
for more than 15 seconds.
If the burner does not light after 15 seconds, release
the control knob, turn it into off position and try to light
the burner again after minimum 1 minute.
Important! In the absence of electricity you can ignite
the burner without electrical device; in this case
approach the burner with a flame, push the relevant
knob down and turn it counter-clockwise to maximum
gas release position.
If the burner accidentally goes out, turn the con-
trol knob to the off position and try to light the
burner again after minimum 1 minute.
The spark generator can start automatically when
you switch on the mains, after installation or a
power cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the symbol .
Warning! Always turn the flame down or switch it
off before you remove the pans from the burner.
Helpful hints and tips
Warning! Refer to the Safety chapters.
Energy savings
• If possible, always put the lids on the pans.
• When the liquid starts to boil, turn down the flame to
barely simmer the liquid.
Use cookware with diameters applicable to the size of
burners.
Burner Diameters of cookware
Triple Crown 180 - 260 mm
Front Semi-rapid 120 - 220 mm
Rear Semi-rapid 120 - 180 mm
Auxiliary 80 - 160 mm
Warning! Make sure that the bottoms of pots do
not stand above the control knobs. If the control
knobs are under the bottoms of pots, the flame heats
them up.
Do not put the same pan on two burners.
Warning! Make sure that pot handles is not
above the front edge of the cooktop. Make sure
that pots are centrally put on the rings in order to get
maximum stability and to get lower gas consumption.
Do not put unstable or damaged pots on the rings to
prevent from spill and injury.
Warning! Do not use a flame diffuser.
18